Volume Year Month Page In/Out-Door Subject Class Author-Designer Model Name/ Article Title Article Description
XXXIII No.6 1999 June/July 4 Out Correction Letter Jetex Bob Hanford  Had corrections in it about past Jetex contest info but mainly had an address for Jetex 150 fuel supplier, Davis Model Products of Milford CT.
XXXIII No.6 1999 June/July 5 In/Out Plans Set Scale Stinson Reliant “SR7A Reluabt SR7A  Scale is ¾”= 1ft which makes the model just over 30". Plans available  @ NFFS plans service
XXXIII No.6 1999 June/July 6,7 NFFS 1999 Membership Survey Len Sherman NFFS 1999 Membership Survey  Len conducted a mail in survey through the digest to find out the general all around condition of the free flight arena of the model aircraft world.
XXXIII No.6 1999 June/July 7 Tips….reactivating  glue Bob Hanford Hot & Sticky Tips on reactivating glue from a glue stick that has dried too soon from the Tulsa Glue Dobbers, Bob Hanford, editor
XXXIII No.6 1999 June/July 8 Out Part I,  Rating of the Quality of the BMJR Honet-B Kit 1/2A Mark Sexton Building the BMJR Honey-B Kit Part I of a two part article on rating the quality of the BJMR 1/2A Honey-B kit and how easily it assembled with very few glitches. To be continued with the flying qualities.
XXXIII No.6 1999 June/July 8,23 Choosing and keeping your cutting tools sharp Steve Gardner
 The Cutting edge or honing your Knife Knowledge The article has five different choices of balsa cutting instruments and what to do to keep them fit to cut. From the Tulsa Glue Dobbers News Letter
XXXIII No.6 1999 June/July 9 Out Plans Set F1G Bob White Coupe D’ Hiver No. 12 The 12th in a series of twin fin high performance coupe class models by Bob White. Plans available through NFFS plans service.
XXXIII No.6 1999 June/July 10,11 Out- Plans Set and information for the CO-2 enthousiest CO-2 Frank Pollard CO2 Revisited This article was written to try to generate more and new interest in the CO2 category of the freefligtht world with pictures, drawings and general information about motors, where they can be purchased and helpful tip on building and flying.
XXXIII No.6 1999 June/July 12 Presidents Column Bob Stalick Presidents Column Items discussed: NFFS website requesting volunteer to keep it updated, Hall of Fame chairman’s,  Nostalgia rule books available, NFFS survey. Other subject were the mystery models for June/July, one design non-power event, and Lee Campbell is up and running with a new address in Muncie Ind. At PO box 3104, Muncie In. 47302, Ph. (765) 289-7753
XXXIII No.6 1999 June/July 14,15,16 Out- Pacifier pressure fuel systems Gas Steve McLellon Not (Just) for Babies…. An introduction to pacifiers This article deals in depth with the baby pacifier fuel pressure system with a picture and description of how to assemble it, reprint from Colorado’s MMM Mac, Rick Pangell, editor.
XXXIII No.6 1999 June/July 17 Out Material comparrison, Tail Booms XX-30 Roy Hanson Tail Booms A chart comparing weights and strengths of various types of materials that could be used in the E-30, E-30X, CO2 or towline-30 class of model.
XXXIII No.6 1999 June/July 18,19 Out- Using your car battery to start your model engine Gas Charles W. Mc Cutchen
 Glowdriver 98, ...Use your car battery to start your Engine   This article deals with using a 12 volt car battery to start your engine using a modified glowdriver 74 creating a glowdriver 98 with the installation of additional circuitry per attached circuit drawing (pg.19)
XXXIII No.6 1999 June/July 20,21 In/Out- Plans Set Rubber The Swallow A 1939 all sheet balsa 16.5” w/s rubber speedster crash proof model. Reduced to 67% of original